Ntp Server Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 80 TACACS+ Server Configuration commands
Command
[no] tacacs-server privilege-mapping
tacacs-server user-mapping {<0-15>
user|oper|admin}
tacacs-server enable
no tacacs-server enable
show tacacs-server
IMPORTANT:
connecting via the console or Telnet/SSH/HTTP/HTTPS. Backdoor for console is always enabled,
so you can connect using notacacs and the administrator password even if the backdoor or
secure backdoor are disabled.
If Telnet backdoor is enabled, type in notacacs as a backdoor to bypass TACACS+ checking,
and use the administrator password to log into the switch. The switch allows this even if TACACS+
servers are available.
If secure backdoor is enabled, type in notacacs as a backdoor to bypass TACACS+ checking,
and use the administrator password to log into the switch. The switch allows this only if TACACS+
servers are not available.

NTP server configuration

These commands enable you to synchronize the switch clock to a Network Time Protocol (NTP) server. By
default, this option is disabled.
The following table describes the NTP Server Configuration commands.
Table 81 NTP Server Configuration commands
Command
[no] ntp primary-server <IP
address>
[no] ntp secondary-server <IP
address>
If TACACS+ is enabled, you must login using TACACS+ authentication when
Description
Prompts for the IP addresses of the primary NTP server to which you want
to synchronize the switch clock. For example, 100.10.1.1.
Command mode: Global configuration
Prompts for the IP addresses of the secondary NTP server to which you
want to synchronize the switch clock. For example, 100.10.1.2.
Command mode: Global configuration
Description
Enables or disables TACACS+ privilege-level mapping.
The default value is disabled.
Command mode: Global configuration
Maps a TACACS+ authorization level to a switch user level.
Enter a TACACS+ privilege level (0-15), followed by the
corresponding HP 1:10GbE switch user level (user, oper,
admin).
Command mode: Global configuration
Enables the TACACS+ server.
Command mode: Global configuration
Disables the TACACS+ server.
Command mode: Global configuration
Displays current TACACS+ configuration parameters.
Command mode: All
Configuration Commands
105