Network Filter Configuration; Route Map Configuration - HP 10GB ETHERNET BL-C SWITCH BMD00022 Command Reference Manual

Network Filter configuration

Command: /cfg/l3/nwf <1-256>
[IP Network Filter
The following table describes the Network Filter Configuration Menu options.
Table 136
Network Filter Configuration Menu options
Command
addr <IP address>
mask <IP subnet mask>
enable
disable
delete
current

Route Map configuration

Command: /cfg/l3/rmap <1-32>
[IP Route Map 1 Menu]
Routing maps control and modify routing information. The map number <1-32> represents the
routing map you wish to configure.
The following table describes the Route Map Configuration Menu options.
Table 137
Route Map Configuration Menu options
Command
alist <1-8>
metric <0-16777214>|none
1 Menu]
addr - IP Address
mask - IP Subnet mask
enable - Enable Network Filter
disable - Disable Network Filter
delete - Delete Network Filter
current - Display current Network Filter configuration
Description
Sets the starting IP address for this filter. The default address is 0.0.0.0.
Sets the IP subnet mask that is used with /cfg/l3/nwf/addr to define the
range of IP addresses that will be accepted by the peer when the filter is
enabled. The default value is 0.0.0.0.
Enables the Network Filter configuration.
Disables the Network Filter configuration.
Deletes the Network Filter configuration.
Displays the current the Network Filter configuration.
alist - Access List number
metric - Set metric of the matched route
type - Set OSPF metric-type of the matched route
prec - Set the precedence of this route map
enable - Enable route map
disable - Disable route map
delete - Delete route map
current - Display current route map configuration
Description
Displays the Access List menu.
Sets the metric of the matched route.
Configuration Menu 163