Vlan Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

VLAN configuration

The commands in this section configure VLAN attributes, change the status of the VLAN, delete the VLAN,
and change the port membership of the VLAN.
By default, the VLANs are disabled except VLAN 1, which is always enabled. The switch supports a
maximum of 1,000 VLANs. VLAN 4095 is reserved for switch management.
NOTE:
See the HP 1:10Gb Ethernet BL-c Switch Application Guide for information about VLANs.
The following table describes the VLAN Configuration commands.
VLAN Configuration commands
Table 117
Command
vlan {<1-4095>}
name {<1-32 characters>}
stg {<1-127>}
member {<port number>}
no member {<port number>}
enable
no enable
no vlan {<1-4095>}
show vlan [<1-4095>]
IMPORTANT:
VLAN and which is not a member of any other VLAN is automatically added to default VLAN 1.
You cannot remove a port from VLAN 1 if the port has no membership in any other VLAN. Also,
you cannot add a port to more than one VLAN unless the port has VLAN tagging turned on.
Description
Enter VLAN configuration mode.
Command mode: Global configuration
Assigns a name to the VLAN or changes the existing name. The default
VLAN name is the first one.
Command mode: VLAN configuration
Assigns a VLAN to a spanning tree group. If MSTP is used, the range
is 0-32 (0 = CIST).
Command mode: VLAN configuration
Adds ports to the VLAN membership.
Command mode: VLAN configuration
Removes ports from the VLAN membership.
Command mode: VLAN configuration
Enables this VLAN.
Command mode: VLAN configuration
Disables this VLAN without removing it from the configuration.
Command mode: VLAN configuration
Deletes this VLAN.
Command mode: Global configuration
Displays the current VLAN configuration.
Command mode: All
All ports must belong to at least one VLAN. Any port which is removed from a
Configuration Commands
135