Rip User Configuration; Ip Information - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

RIP user configuration

The following command displays RIP user information:
show interface ip [<1-256>] rip
Command mode: All
RIP USER CONFIGURATION :
RIP on updat 30
RIP Interface 2 : 102.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1
auth none,key none
RIP Interface 3 : 103.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1

IP information

The following command displays Layer 3 information:
show layer3 information
Command mode: All
IP information:
Interface information:
1: 10.80.23.243
250: 10.20.7.144
Default gateway information: metric strict
1: 10.80.22.1,
254: 10.20.1.1,
Current BOOTP relay settings: OFF
0.0.0.0, 0.0.0.0
Current IP forwarding settings: OFF, dirbr disabled
Current network filter settings:
none
Current route map settings:
The following interface and default gateway information is displayed:
Interface number
IP address
IP mask
IP broadcast address
Operational status
255.255.254.0 10.80.23.255,
255.255.0.0 10.20.255.255,
vlan any, up active
vlan 4095, up active
Information Commands
vlan 1, up
vlan 4095, up
53