Layer 3 Configuration; Ip Interface Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Layer 3 configuration

The following table describes basic Layer 3 Configuration commands. The following sections provide
more detailed information and commands.
L3 Configuration commands
Table 118
Command
interface ip {<1-256>}
route-map <1-32>
router rip
router ospf
router vrrp
ip router-id <IP address>
show layer3

IP interface configuration

The switch can be configured with up to 256 IP interfaces. Each IP interface represents the switch on an IP
subnet on your network. The IP Interface option is disabled by default.
The following table describes the IP Interface Configuration commands.
Table 119 IP Interface Configuration commands
Command
interface ip {<1-256>}
ip address {<IP address>}{<IP
netmask>}
vlan {<1-4095>}
[no] relay
Description
Enter IP Interface mode.
Command mode: Global configuration
Enter IP Route Map mode.
Command mode: Global configuration
Enter Router RIP mode.
Command mode: Global configuration
Enter Router OSPF mode.
Command mode: Global configuration
Enter VRRP configuration mode.
Command mode: Global configuration
Sets the router ID.
Command mode: Global configuration
Displays the current IP configuration.
Command mode: All except User EXEC
Description
Enter IP interface mode.
Command mode: Global configuration
Configures the IP address and mask of the switch interface using dotted
decimal notation.
Command mode: Interface IP
Configures the VLAN number for this interface. Each interface can
belong to one VLAN, though any VLAN can have multiple IP interfaces
in it.
Command mode: Interface IP
Enables or disables the BOOTP relay on this interface. The default value
is enabled.
Command mode: Interface IP
Configuration Commands
136