HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual page 180

When the above requirements are met, use the following procedure to download the new software to the
HP 1:10GbE switch.
1. In Privileged EXEC mode, enter:
Switch# copy tftp {<image1|image2|boot-image>}
-or-
Switch# copy ftp {<image1|image2|boot-image>}
2. Enter the name of the switch software to be replaced:
Enter name of switch software image to be replaced
["image1"/"image2"/"boot"]: <image>
3.
Enter the hostname or IP address of the FTP/TFTP server:
Address or name of remote host: <server name or IP address>
4. Enter the name of the new software file on the server:
Source file name: <filename>
5.
The exact form of the name will vary by server. However, the file location is normally relative to the
FTP or TFTP directory.
6.
Enter the user name, if you are using a FTP server:
Enter username for FTP server or hit return for TFTP server: <userID>
7. Enter the password for the FTP server (if prompted):
Enter password for username on FTP server: <password>
8.
The system prompts you to confirm your request.
9. You should next select a software image to run, as described in the "Selecting a Soft Image to Run"
section.
10.
If you are loading an image from which you are not currently booted, the system prompts you to
change the image.
image2 currently contains Software Version 1.0.0
that was downloaded at 15:46:36 Wed Mar 21, 2007.
New download will replace image2 with file "1.0.1_OS.img"
from TFTP server 10.168.2.4.
Confirm download operation [y/n]: y
Invoking TFTP over port 69...
Starting download...
File appears valid
Download in
progress....................................................
Image download complete (1333953 bytes)
Writing to flash...This takes about 90 seconds. Please wait
Write complete (1333953 bytes), now verifying FLASH...
Verification of new image2 in FLASH successful.
image2 now contains Software Version 1.0.1
Switch is currently set to boot software image1.
Do you want to change that to the new image2? [y/n] y
Next boot will use new software image2.
Boot Options
180