Idle Timeout; Typographical Conventions - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

User access levels
Table 2
User account
User
Oper
Admin
NOTE:
With the exception of the admin user, access to each user level can be disabled by setting
the password to an empty value.
Once you enter the administrator password and it is verified, you are given complete access to the
HP 1:10GbE switch.

Idle timeout

By default, the HP 1:10GbE switch disconnects the console, Telnet, or SSH session after five minutes of
inactivity. This function is controlled by the idle timeout parameter, which can be set from 1 to 60 minutes.
To change this parameter, see the "System configuration" section in the "Configuration Commands"
chapter.

Typographical conventions

The following table describes the typographic styles used in this guide:
Typographical conventions
Table 3
Typeface or symbol
angle brackets < >
bold body text
plain Courier text
Description and tasks performed
The User has no direct responsibility for switch management. He or she can view all switch
status information and statistics, but cannot make any configuration changes to the switch.
The user account is enabled by default, and the default password is user.
The Operator has no direct responsibility for switch management. He or she can view all switch
status information and statistics, but cannot make any configuration changes to the switch.
By default, the operator account is disabled and has no password.
The super user administrator has complete access to all command modes on the switch,
including the ability to change both the user and administrator passwords.
The admin account is enabled by default, and the default password is admin.
Meaning
Indicate a variable to enter based on the description inside the brackets. Do not type
the brackets as you enter the command.
Example: If the command syntax is
ping <IP address>
Enter: ping 192.32.10.12
Indicates user-interface objects, such as buttons and tabs.
Indicates command syntax and system output (for example: prompts and system
messages). Example:
configure terminal
ISCLI reference
13