Re-Mark Update User Priority Configuration; Acl Re-Mark Out-Of-Profile Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Re-Mark Update User Priority configuration

The following table describes the Update User Priority Configuration commands.
Table 163 ACL Update User Priority Configuration commands
Command
access-control list <1-896>
re-mark in-profile dot1p <0-7>
[no] access-control list <1-896>
re-mark in-profile use-tos-
precedence
default access-control list
<1-896> re-mark
show access-control list <1-896>
re-mark

ACL Re-mark Out-of-Profile configuration

The following table describes the Re-mark Out-of-Profile Configuration commands.
Table 164 ACL Re-mark Out-of-Profile Configuration commands
Command
access-control list <1-896>
re-mark out-profile dscp
<0-63>
default access-control list
<1-896> re-mark
show access-control list
<1-896> re-mark
Description
Defines 802.1p value. The value is the priority bits information in
the packet structure.
Command mode: Global configuration
Enable or disable mapping of TOS (Type of Service) priority to
802.1p priority for In-Profile packets. When enabled, the TOS
value is used to set the 802.1p value.
Command mode: Global configuration
Resets UP1P settings to their default values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC
Description
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the
selected value. The switch sets the DSCP value on Out-of-Profile packets.
Command mode: Global configuration
Resets the update DSCP parameters for Out-of-Profile packets to their
default values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC
Configuration Commands
168