Network Filter Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Reference Manual
Hp 1:10gb ethernet bl-c switch for c-class bladesystem browser-based interface reference guide
Hide thumbs
Also See for 438031-B21 - 1:10Gb Ethernet BL-c Switch:
- Command reference manual (208 pages) ,
- Application manual (195 pages) ,
- Cli reference manual (190 pages)
Table of Contents
Advertisement
Network Filter Configuration
To display the following form, go to the Network Filters Configuration form. Select a network filter ID
number, or open the Network Filters folder and click Add Network Filter.
The following table describes the Network Filter Configuration controls:
Network Filter Configuration controls
Table 139
Control
Network Filter Identifier (1-256)
IP Address
Enabled?
Subnet Mask
Description
Sets the numeric identifier for this network filter.
Sets the starting IP address for this filter. The default address is 0.0.0.0.
Enables or disables the Network Filter configuration.
Sets the IP subnet mask that is used to define the range of IP addresses that will be
accepted by the peer when the filter is enabled. The default value is 0.0.0.0.
Configuring the switch
199
Advertisement
Table of Contents
