IGMPv3 Snooping configuration
The following table describes the IGMP version 3 Snooping Configuration commands.
Table 140
IGMPv3 Snooping commands
Command
ip igmp snoop igmpv3 sources
<1-64>
{
}
[no] ip igmp snoop igmpv3 v1v2
[no] ip igmp snoop igmpv3
exclude
ip igmp snoop igmpv3 enable
no ip igmp snoop igmpv3 enable
show ip igmp
IGMP static multicast router configuration
The following table describes the Static Multicast Router Configuration commands.
NOTE:
When you configure a static multicast router on a VLAN, the process of learning multicast
routers is disabled for that VLAN.
Table 141
IGMP Static Multicast Router commands
Command
ip igmp mrouter <port number>
<1-4094> <1-3>
no ip igmp mrouter <port
number> <1-4094> <1-3>
Description
Configures the maximum number of IGMP multicast sources to snoop
from within the group record. Use this command to limit the number
of IGMP sources to provide more refined control.
Command mode: Global configuration
Enables or disables snooping on IGMP version 1 and version 2
reports. When disabled, the switch drops IGMPv1 and IGMPv2
reports. The default value is enabled.
Command mode: Global configuration
Enables or disables snooping on IGMPv3 Exclude Reports. When
disabled, the switch ignores Exclude Reports. The default value is
enabled.
Command mode: Global configuration
Enables IGMP version 3. The default value is enabled.
Command mode: Global configuration
Disables IGMP version 3.
Command mode: Global configuration
Displays the current IGMP configuration.
Command mode: All except User EXEC
Description
Selects a port/VLAN combination on which the static multicast router
is connected, and configures the IGMP version (1, 2, or 3) of the
multicast router.
Command mode: Global configuration
Removes a static multicast router from the selected port/VLAN
combination.
Command mode: Global configuration
Configuration Commands
152