Tunnel Isatap Query-Interval; Tunnel Isatap Solicitation-Interval - Dell PowerConnect 5424 Command Line Interface Manual

Example
The following example sets the local (source) tunnel interface IPv4 address.
Console (config)# interface tunnel 1
Console (config-tunnel)# tunnel source auto

tunnel isatap query-interval

The tunnel isatap query-interval Global Configuration mode command configures the interval between
DNS Queries (before the IP address of the ISATAP router is known) for the automatic tunnel router
domain name. Use the no form of this command to return to default.
Syntax
• tunnel isatap query-interval seconds
• no tunnel isatap query-interval
• seconds — Specify the number of seconds between DNS Queries. (Range: 10 – 3600)
Default Configuration
10 seconds.
Command Mode
Global Configuration mode.
User Guidelines
• This command determines the interval of DNS queries before the IP address of the ISATAP router is
known. When the IP address is known the robustness level that is set by the tunnel isatap robustness
global configuration command determines the refresh rate.
Example
The following example configures the interval between DNS Queries for the automatic tunnel router
domain to 60 seconds.
Console (config)# tunnel isatap query-interval 60

tunnel isatap solicitation-interval

The tunnel isatap solicitation-interval Global Configuration mode command configures the interval
between ISATAP router solicitations messages (when there is no active ISATAP router). Use the no form
of this command to return to default.
436
Tunnel