Dell PowerConnect 5424 Command Line Interface Manual page 171

The following table describes the fields shown in the display:
Field
InOctets
InUcastPkts
InMcastPkts
InBcastPkts
OutOctets
OutUcastPkts
OutMcastPkts
OutBcastPkts
Alignment Errors
FCS Errors
Single Collision Frames
Multiple Collision
Frames
SQE Test Errors
Deferred Transmissions
Late Collisions
Excessive Collisions
Internal MAC Tx Errors
Carrier Sense Errors
Oversize Packets
Internal MAC Rx Errors
Description
Counted received octets.
Counted received Unicast packets.
Counted received Multicast packets.
Counted received Broadcast packets.
Counted transmitted octets.
Counted transmitted Unicast packets.
Counted transmitted Multicast packets.
Counted transmitted Broadcast packets.
A count of frames received that are not an integral number of octets in length
and do not pass the FCS check.
Counted frames received that are an integral number of octets in length but
do not pass the FCS check.
Counted frames that are involved in a single collision, and are subsequently
transmitted successfully.
A count of frames that are involved in more than one collision and are
subsequently transmitted successfully
A count of times that the SQE TEST ERROR is received. The SQE TEST
ERROR is set in accordance with the rules for verification of the SQE
detection mechanism in the PLS Carrier Sense Function as described in
IEEE Std. 802.3, 2000 Edition, section 7.2.4.6.
A count of frames for which the first transmission attempt is delayed because
the medium is busy.
Counted times that a collision is detected later than one slotTime into the
transmission of a packet.
Counted frames for which transmission fails due to excessive collisions.
Counted frames for which transmission fails due to an internal MAC sublayer
transmit error.
The number of times that the carrier sense condition was lost or never
asserted when attempting to transmit a frame.
Counted frames received that exceed the maximum permitted frame size.
Counted frames for which reception fails due to an internal MAC sublayer
receive error.
Ethernet Configuration Commands
171