Dell PowerConnect 5424 Command Line Interface Manual page 71

clear logging file
clear spanning-tree detected-
protocols
clock set
configure
copy
crypto certificate request
dot1x re-authenticate
ipv6 set mtu
login
reload
set interface active
set system
show arp
show authentication methods
show banner
show bootvar
show bridge address-table
show bridge address-table count Displays the number of addresses present in all VLANs or at specific VLAN.
show bridge multicast address-
table
show bridge multicast filtering
show copper-ports cable-length Displays the estimated copper cable length attached to a port.
show copper-ports tdr
show crypto key mypubkey
show crypto key pubkey-chain
ssh
show crypto certificate
mycertificate
show dot1x
show dot1x advanced
show dot1x users
Clears messages from the logging file
Restarts the protocol migration process on all interfaces or on the specified
interface.
Manually sets the system clock.
Enters the global configuration mode.
Copies files from a source to a destination.
Generates and displays certificate requests for HTTPS.
Manually initiates a re-authentication of all 802.1X-enabled ports or the specified
802.1X-enabled port.
Sets the MTU size of IPv6 packets sent on an interface.
Returns to User EXEC mode.
Reloads the operating system.
Reactivates an interface that was suspended by the system.
Activates/deactivates specified features.
Displays entries in the ARP table.
Displays information about the authentication methods.
Displays the banners configuration.
Displays the active system image file that the device loads at startup
Displays dynamically created entries in the bridge-forwarding database.
Displays Multicast MAC address table information.
Displays the Multicast filtering configuration.
Displays the last TDR (Time Domain Reflectometry) tests on specified ports.
Displays the SSH public keys stored on the device.
Displays SSH public keys stored on the device.
Displays the SSL certificates of the device
Displays allowed multiple hosts on an 802.1X-authorized port, that has the dot1x
port-control Interface Configuration command set to auto.
Displays 802.1X enhanced features for the switch or for the specified interface.
Displays 802.1X statistics for a specified interface.
71
Command Modes