Lldp Management-Address - Dell PowerConnect 5424 Command Line Interface Manual

User Guidelines
There are no user guidelines for this command.
Example
The following example specifies which optional TLV (2)s from the basic set should be transmitted.
Console(config)# interface ethernet g5
Console(config-if)# lldp optional-tlv sys-name

lldp management-address

The lldp management-address Interface Configuration mode command specifies the management
address that would be advertised from an interface. Use the no form of this command to stop advertising
management address information.
Syntax
• lldp management-address ip-address
• no management-address
• ip-address — Specifies the management address to advertise.
Default Configuration
No IP address is advertised.
Command Modes
Interface Configuration (Ethernet) mode.
User Guidelines
• Each port can advertise one IP address.
• Only static IP addresses can be advertised.
Example
The following example specifies management address that would be advertised from an interface as
192.168.0.1.
Console(config)# interface ethernet g5
Console(config-if)# lldp management-address 192.168.0.1
258
LLDP Commands