Dell PowerConnect 5424 Command Line Interface Manual page 77

permit-tcp {any|{ source source-wildcard}} {any|source-port} {any|{ destination destination-
•
wildcard}} {any|destination-port} [dscp number | ip-precedence number] [flags list-of-flags] [src-
port-wildcard source-port-wildcard] [dst-port-wildcard source-port-wildcard]
• permit-udp {any|{ source source-wildcard}} {any| source-port} {any|{destination destination-
wildcard}} {any|destination-port} [dscp number | ip-precedence number] [src-port-wildcard source-
port-wildcard] [dst-port-wildcard source-port-wildcard]
• source — Specifies the source IP address of the packet.
• source-wildcard — Specifies wildcard bits to be applied to the sources IP address by placing 1s in
bit positions to be ignored.
• destination — Specifies the destination IP address of the packet.
• destination-wildcard — Specifies wildcard bits to be applied to the destination IP address by
placing 1s in bit positions to be ignored.
• protocol — Specifies the name or the number of an IP protocol. Available protocol names: icmp,
igmp, ip, tcp, egp, igp, udp, hmp, rdp, idpr, idrp, rsvp, gre, esp, ah, eigrp, ospf, ipip, pim, l2tp,
isis. (Range: 0 - 255)
• dscp number — Specifies the DSCP value.
ip-precedence number — Specifies the IP precedence value.
•
• icmp-type — Specifies an ICMP message type for filtering ICMP packets. Enter a number or
one of the following values: echo-reply, destination-unreachable, source-quench, redirect,
alternate-host-address, echo-request, router-advertisement, router-solicitation, time-exceeded,
parameter-problem, timestamp, timestamp-reply, information-request, information-reply,
address-mask-request, address-mask-reply, traceroute, datagram-conversion-error,
mobile-host-redirect, mobile-registration-request, mobile-registration-reply,
domain-name-request, domain-name-reply, skip, photuris. (Range: 0 - 255)
• icmp-code — Specifies an ICMP message code for filtering ICMP packets. (Range: 0 - 255)
• igmp-type — Specifies IGMP packets filtered by IGMP message type. Enter a number or one of
the following values: host-query, host-report, dvmrp, pim, cisco-trace, host-report-v2, host-leave-
v2, host-report-v3. (Range: 0 - 255)
• destination-port — Specifies the UDP/TCP destination port. (Range: 0 - 65535)
• destination-port-wildcard — Specifies wildcard bits to be applied to the destination port by placing
1s in bit positions to be ignored.
• source-port — Specifies the UDP/TCP source port. (Range: 0 - 65535)
• source-port-wildcard — Specifies wildcard bits to be applied to the source port by placing 1s in bit
positions to be ignored.
• flags list-of-flags — Specifies the list of TCP flags. If a flag is set, it is prefixed by "+". If a flag is
not set, it is prefixed by "-". Available options are +urg, +ack, +psh, +rst, +syn, +fin, -urg, -ack,
-psh, -rst, -syn and -fin. The flags are concatenated to a one string. For example: +fin-ack.
• byte — Specifies the user-defined bytes.
77
ACL Commands