Dell PowerConnect 5424 Command Line Interface Manual page 66

Powerconnect 5400 series
Hide thumbs Also See for PowerConnect 5424:
Table of Contents

Advertisement

radius-server retransmit
radius-server source-ip
radius-server source-ipv6
radius-server timeout
rmon alarm
rmon event
rmon table-size
snmp-server community
snmp-server contact
snmp-server enable traps
snmp-server host
snmp-server location
snmp-server set
snmp-server trap authentication Enables the switch to send Simple Network Management Protocol traps
sntp authenticate
sntp authentication-key
spanning-tree
spanning-tree bpdu
spanning-tree forward-time
spanning-tree hello-time
spanning-tree max-age
spanning-tree mode
spanning-tree pathcost method Sets the default pathcost method.
spanning-tree priority
tacacs-server key
66
Command Modes
Specifies the number of times the software searches the list of RADIUS
server hosts.
Specifies the source IP address used for communication with RADIUS
servers.
Specifies the source IPv6 address used for the IPv6 communication
with RADIUS servers.
Sets the interval for which a router waits for a server host to reply.
Configures alarm conditions.
Configures a RMON event.
Configures the maximum RMON tables sizes.
Sets up the community access string to permit access to SNMP
protocol.
Sets up a system contact.
Enables the switch to send SNMP traps or SNMP notifications.
Specifies the recipient of Simple Network Management Protocol
notification operation.
Sets up the information on where the device is located.
Sets SNMP MIB value by the CLI.
when authentication failed.
Grants authentication for received Network Time Protocol (NTP)
traffic from servers.
Defines an authentication key for Simple Network Time Protocol
(SNTP).
Enables spanning tree functionality.
Defines BPDU handling when spanning tree is disabled on an interface
Configures the spanning tree bridge forward time.
Configures the spanning tree bridge Hello Time.
Configures the spanning tree bridge maximum age.
Configures the spanning tree protocol.
Configures the spanning tree priority.
Sets the authentication encryption key used for all TACACS+
communications between the device and the TACACS+ daemon.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerconnect 5448

Table of Contents