Exec-Timeout - Dell PowerConnect 5424 Command Line Interface Manual

Examples
The following example sets the line for automatic baud rate detection.
Console (config)# line console
Console(config-line)# autobaud

exec-timeout

The exec-timeout Line Configuration mode command sets the interval that the system waits until user
input is detected. Use the no form of this command to restore the default setting.
Syntax
• exec-timeout minutes [seconds]
• no exec-timeout
• minutes — Integer that specifies the number of minutes. (Range: 0 - 65535)
• seconds — Additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode.
User Guidelines
• To specify no timeout, enter the exec-timeout ("0 0") command.
Examples
The following example configures the interval that the system waits until user input is detected to 20
minutes.
Console (config)# line console
Console(config-line)# exec-timeout 20
249
Line Commands