Switch Binding - Membership List Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

The WWNs of devices and switches that can currently connect to switch ports are listed in the
Switch Membership List.
Figure 79 Switch Binding – Membership List dialog box
See ""Editing the Switch Membership
Membership List is populated with WWNs according to options set in the Switch Binding – State
Change dialog box.
2. If nicknames are configured for WWNs through HAFM and you want these to display instead of
WWNs in this dialog box, click Display Options. The Display Options dialog box is displayed.
3. Click Nickname, then click OK.
4. To prohibit connection to a switch port from a WWN currently in the Switch Membership List,
click the WWN or nickname in the Switch Membership List, then click Remove. The WWN or
nickname moves to the Attached Nodes List. WWNs can only be removed from the fabric if any
of the following is true:
• The switch is offline.
• Switch Binding is disabled.
• The switch or device with the WWN is not connected to the switch.
• Switch Binding is not enabled for the same port type as enabled for the Connection Policy in
the Switch Binding – State Change dialog box. For example, a WWN for a switch attached
to an E_Port can be removed if the Switch Binding Connection Policy was enabled to
Restrict F_Ports.
• The switch or device with the WWN is connected to a port that is blocked.
5. The switch or device with the WWN is not currently connected to the switch (detached node).
6. WWNs can be added to the Switch Membership List (and thereby allowed connection) when
Switch Binding is either enabled or disabled. To allow connection to a switch port from a WWN
in the Attached Nodes List, select the WWN or nickname in the Attached Nodes List, then click
Add. The WWN or nickname moves to the Switch Membership List.
List" on page 130" for information on how the Switch
HA-Fabric Manager user guide 131