HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 222

Table 29 HAFM messages (continued)
Message
Cannot display route. All
switches in route must
support routing.
Cannot display route.
Device is not a member of
a zone in the active zone
set.
Cannot display route on
one switch fabric.
Cannot display route.
error 9.
Cannot display route. No
active zone enabled.
Cannot have spaces in
field.
Cannot modify a zone set
with an invalid name.
Rename zone set and try
again.
Cannot modify a zone
with an invalid name.
Rename zone and try
again.
222 Informational and error messages
Description
You cannot show the
route through a fabric that
has switches or directors
which do not support
routing.
You cannot show the
route for a device that is
not a member of a zone
in the active zone set. The
source node that you
have selected is not part
of a zone in the active
zone set.
You cannot show routes
between end devices in a
fabric when configuring
Show Routes (Configure
menu).
An internal error has
occurred while trying to
view routes.
You cannot show the
route through a fabric
with no active zone.
Spaces are not allowed
as part of the entry for
this field.
A zone set must have a
valid name to be
modified.
A zone must have a valid
name to be modified.
Action
The route must contain only Edge
Switch 2/16s, Edge Switch 2/32s,
Director 2/64s, or Director
2/140s.
Enable the default zone or activate
the zone for the device before
attempting to show the route.
Error is displayed when attempting
to show routes on a fabric with only
one switch. Configure Show Routes
on a multiswitch fabric.
Contact the next level of support to
report the problem.
Enable the default zone or activate
a zone set before attempting to
show the route.
Delete spaces from the field entry.
Assign a valid name to the zone
set, then modify the name through
the Modify Zone Set dialog box.
Assign a valid name to the zone,
then modify the name through the
Modify Zone Set dialog box.