Adding Trap Recipients; Configure Trap Forwarding Dialog Box; Add Trap Recipient Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

The Configure Trap Forwarding dialog box is displayed
Figure 64

Configure Trap Forwarding dialog box

2. If necessary, add trap recipients to the Available Recipients list.
See "Adding trap
3. Select the recipient that you want to provide trap messages to in the Available Recipients list.
4. Click the right arrow button.
5. Scan the Selected Recipients list, and, if necessary, select recipients to move from the list and
then click left arrow button.
6. Select the Enable Trap Forwarding check box.
7. Click OK.

Adding trap recipients

To add a trap recipient:
1. Select Monitor > Trap Forwarding.
The Configure Trap Forwarding dialog box is displayed
2. Click Add.
The Add Trap Recipient dialog box is displayed
Figure 65

Add Trap Recipient dialog box

3. Enter the appropriate information in the following boxes:
• Description
• IP Address
• Port
110 Configuring SAN products and fabrics
recipients" on page 1 10 for instructions.
(Figure 64).
(Figure 64).
(Figure 65).