HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 226

Table 29 HAFM messages (continued)
Message
Error removing zone or
zone member.
Error transferring files
< message >.
Fabric Log will be lost
once the fabric unpersists.
Do you want to continue?
Fabric member could not
be found.
Fabric not persisted.
Field cannot be blank.
File transfer aborted.
HAFM error <error
number 1 through 8 >.
Management server
could not log you on.
Verify your username and
password.
226 Informational and error messages
Description
The HAFM application
encountered an internal
error.
An error occurred while
transferring files from the
PC hard drive to the
HAFM application. The
message varies,
depending on the
problem.
When you unpersist a
fabric, the corresponding
fabric log is deleted.
A fabric member does not
exist when the application
prepared to find a route,
find a route node, or
gather route information
on that fabric member.
You attempted to refresh
or clear the log, after a
fabric was unpersisted.
When you unpersist a
fabric, the corresponding
fabric log is deleted.
The data field requires an
entry and cannot be left
blank.
You aborted the file
transfer process.
The HAFM application
encountered an internal
error (1 through 8
inclusive) and cannot
continue operation.
An incorrect username or
password (both case
sensitive) was used while
attempting to log in to the
HAFM application.
Action
Try the operation again. If the
problem persists, contact the next
level of support.
Try the file transfer operation
again. If the problem persists,
contact the next level of support.
Click Yes to unpersist the fabric or
No to cancel the operation.
Ensure the product is incorporated
into the fabric and retry the
operation. If the problem persists,
contact the next level of support.
Click OK to continue. Ensure the
fabric is persisted before
attempting to refresh or clear the
Fabric Log.
Enter appropriate information in
the data field.
Verify the file transfer is to be
aborted, then click OK to continue.
Contact the next level of support to
report the problem.
Verify the username and password
with the customer's network
administrator and retry the
operation.