Monitoring The Hafm Application; Starting And Stopping Hafm Services; Viewing User Sessions; Disconnecting Users - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Monitoring the HAFM application

This section describes monitoring the HAFM application.

Starting and stopping HAFM Services

HAFM Services is the software application that provides services to the HAFM application. HAFM
Services runs only on the HAFM appliance.
You can start or stop HAFM Services from the desktop:
1. Select Start > Programs > HP StorageWorks ha-fabric manager 8.8 > Stop Services.
Or
Select Start > Programs > HP StorageWorks ha-fabric manager 8.8 > Start Services.

Viewing user sessions

Monitoring clients is an important part of maintaining the SAN because more than one client can
access an appliance at a time. You can view user sessions to determine which clients are logged in
to the appliance.
To display the Active Sessions dialog box:
1. Select SAN > Active Sessions.
The Active Sessions dialog box is displayed
Figure 9

Active Sessions dialog box

The Active Sessions dialog box shows information about the active users. If a user is logged in from
more than one location, there is a separate entry for each session.

Disconnecting users

To disconnect a user:
1. Select a user and click Disconnect User to disconnect the user from the appliance.
The appliance immediately shuts down the appliance-client connection. The status bar on the
client displays that the appliance connection was lost. All products and connections on the
Physical Map stay in the condition they were in when the session ended; they do not turn grey.
The client displays a message stating that a user disconnected the client from the appliance.
(Figure 9).
HA-Fabric Manager user guide 41