Configure Switch Operating Parameters; Configure Switch Parameters Dialog Box - HP storageworks 2/32 Installation Manual

Configure Switch Operating Parameters

Use the procedures in this section to set parameters on the switch for fabric
operation through the Configure Switch Parameters dialog box. These operating
parameters are stored in NVRAM on the switch.
1. The switch must be offline to change Preferred Domain ID and other
2. Choose Configure > Operating Parameters > Switch Parameters. The
Figure 16: Configure Switch Parameters dialog box
Note:
defaults. The only exception is the Preferred Domain ID. Change this value if the switch
will participate in a multiswitch fabric.
3. Use information in the
4. After you change settings, click the Activate button.
5. Set the switch online. For instructions, see
Edge Switch 2/32 Installation Guide
operating parameters. Ensure the switch is set offline. For instructions, see
"Set the Switch Offline" on page 52.
Caution: Setting the switch offline terminates all Fibre Channel connections.
Configure Switch Parameters dialog box displays
Ordinarily, you do not need to change values in this dialog box from their
settings as required for parameters in this dialog box.
page 52.
Installing and Configuring the Edge Switch 2/32
"Switch Parameters" section, which follows, to change
"Set the Switch
(Figure 16).
Online" on
55