HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 258

Table 30 Element Manager messages (continued)
Message
The management server is
busy processing a request
from another Element
Manager.
The optical transceiver is
not installed.
The switch did not accept
the request.
The maximum number of
address configurations
has been reached.
The switch did not
respond in the time
allowed.
The switch is busy saving
maintenance information.
The switch must be offline
to change the
Management Style.
The switch must be offline
to configure.
This feature is not
installed. Please contact
your sales representative.
258 Informational and error messages
Description
The HAFM appliance is
processing a request from
another instance of an
Element Manager, and
cannot perform the
requested operation.
Information is not
available for a port
without an optical
transceiver installed.
The director or switch
cannot perform the
requested action.
The maximum number of
saved address
configurations has been
reached.
While waiting to perform
a requested action, the
director or switch timed
out.
The director or switch
cannot perform the
requested action because
it is busy saving
maintenance information.
The firmware is below the
required level and you
attempted to change the
management style.
A configuration changed
was attempted for a
configuration requiring
offline changes.
This feature has not been
installed.
Action
Wait until the process is completes,
then perform the operation again.
Install an SFP optical transceiver in
the port.
Retry the operation. If the condition
persists, contact the next level of
support.
Delete configurations no longer
needed to allow new configuration
to be saved.
Retry the operation. If the condition
persists, contact the next level of
support.
Retry the operation later. If the
condition persists, contact the next
level of support.
Choose Set Online State from the
Maintenance menu and click Set
Offline. Then change the
management style. Set the director
or switch back online when
finished.
Take the appropriate actions to set
the director or switch offline before
attempting the configuration
change.
Contact your sales representative.