Configuring Remote Management Access; Disconnecting A User; Remote Access Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Configuring remote management access

To specify the network addresses that can access the appliance:
1. Select SAN > Remote Access.
The Remote Access dialog box is displayed
Figure 36

Remote Access dialog box

2. Select Allow remote management sessions to allow others to access the appliance remotely.
3. Enter the maximum number of remote sessions you want to allow.
4. Select whether to allow all or some network addresses to connect.
5. If you select Only network addresses below to connect or All network addresses EXCEPT those
below to connect, enter the appropriate addresses in the Network Address field.
• To add an address, click Add, enter a network address, and then click OK.
• To remove an address, highlight the address in the table and click Remove.
6. Click OK.

Disconnecting a user

To disconnect a use:
1. Select SAN > Active Sessions.
The Active Sessions dialog box is displayed.
(Figure 36).
HA-Fabric Manager user guide 77