HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 221

Table 29 HAFM messages (continued)
Message
Are you sure you want to
delete this zone set?
Are you sure you want to
overwrite this zone set?
Are you sure you want to
remove all members from
this zone?
Cannot add a switch to a
zone.
Cannot connect to
management server.
Cannot delete product.
Cannot disable Fabric
Binding while Enterprise
Fabric Mode is active.
Cannot display route. All
switches in route must be
managed by the same
server.
Description
The selected zone set will
be deleted from the zone
library.
The selected zone set will
be overwritten in the
zoning library.
All members will be
deleted from the selected
zone.
The device that you are
attempting to add to the
zone is a switch, which
cannot be added to a
zone.
The HAFM application at
a remote workstation
could not connect to the
HAFM appliance.
The selected product
cannot be deleted.
You attempted to disable
Fabric Binding through
the Fabric Binding dialog
box, but Enterprise Fabric
Mode was enabled.
You cannot show the
route between devices
that are attached to
switches or directors
managed by a different
HAFM appliance.
Action
Click Yes to delete the zone set or
No to cancel the operation.
Click Yes to overwrite or No to
cancel.
Click Yes to delete the members or
No to cancel the operation.
Specify the port number or
corresponding WWN for the
device you want to add to the
zone.
Verify the HAFM appliance IP
address is valid.
Verify the HAFM appliance-to-
product link is up. If the link is up:
• The HAFM appliance can be
busy.
• Another Element Manager
instance can be open.
• You cannot have permission to
delete the product.
Disable Enterprise Fabric Mode
through the Enterprise Fabric Mode
dialog box in the HAFM
application before disabling Fabric
Binding.
Make sure devices named in Show
Routes dialog box are attached to
products managed by this HAFM
appliance.
HA-Fabric Manager user guide 221