HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 238

Table 30 Element Manager messages (continued)
Message
Are you sure you want to
delete firmware version?
Are you sure you want to
delete this address
configuration?
Are you sure you want to
send firmware version?
Cannot change Port Type
while Management Style
is FICON without
SANtegrity feature.
Please contact your sales
representative.
Cannot disable Switch
Binding while Enterprise
Fabric Mode is active and
the switch is Online.
Cannot disable Insistent
Domain ID while Fabric
Binding is active.
Cannot enable
beaconing on a failed
FRU.
238 Informational and error messages
Description
This message requests
confirmation to delete a
firmware version.
Firmware library can store
up to 8 firmware versions.
Confirmation to delete the
selected address
configuration.
This message requests
confirmation to send a
firmware version from the
HAFM appliance's
firmware library to the
director. Firmware library
can store up to 8
firmware versions.
Firmware is below the
required level and you
attempted to change a
port type in the Configure
Ports dialog box while
FICON management
style, but the optional
SANtegrity Binding
feature is not installed.
You attempted to disable
Switch Binding through
the Switch Binding
Change State dialog box,
but Enterprise Fabric
Mode is enabled.
You attempted to disable
the Insistent Domain ID
parameter through the
Configure Switch
Parameters dialog box,
but Fabric Binding is
enabled.
Occurs when selecting
Enable Beaconing option
for a failed FRU.
Action
Click Yes to delete the firmware
version or No to abort the
operation.
Click Yes to confirm the deletion of
the address configuration or No to
cancel the operation.
Click Yes to send the firmware
version or No to abort the
operation.
Informational message. If the
firmware is below the required
level, install SANtegrity Binding
before changing port types in the
Configure Ports dialog box while in
FICON management style.
You must either disable Enterprise
Fabric Mode using the Enterprise
Fabric Mode dialog box in the
HAFM application or set the switch
offline before you can disable
Switch Binding.
Disable Fabric Binding through the
Fabric Binding dialog box before
disabling these parameters.
Replace FRU and enable
beaconing again or enable
beaconing on operating FRU.