Creating Double Stitch - Brother BAS-311E Instruction Manual

Creating double stitch

Command to be used
2 M
M
7 8 9 L
7 8 8 L
1 1 E
If sharp angles or fine curves are included in the pattern sheet, the desired double stitch may
not be achieved.
1. Select the sewing start position with
2. Determine the width and input
3. Move the needle with
4. Move the needle to the corner point and input
Chapter 3 Programming with Command Function
Creating double stitch in the reverse direction to the sewing
path. Input the width of double stitch in
Values 1.0 - 9.9 mm are available for the width.
Example Width
1.5 mm
Input the stitch length in
Carrying out double stitch on the left side to the sewing path.
Carrying out double stitch on the right side to the sewing
path.
Starting double stitch calculations.
(This is the end code. Refer to page 179 for details.)
2
to select the second point, then press
Programmer
.
Input
215
.
and press L
.
M
.
7 8 L
.
.
L
173