Table 59: Show Mpls Tunnels Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

JUNOSe 11.0.x BGP and MPLS Configuration Guide
phb-id 2
path option 2
FastEthernet2/4.1
Tunnel tail-de090106-1-18a for
0 hcOctets, 0 errors, 0 discardPkts
In the output for Tunnel 2 shown here, the line phb-id 2 indicates that the tunnel is
an L-LSP with PHB-ID 2. You can then display the output of the show mpls phb-id
command to determine the corresponding PSC.
A result of Incomplete Configuration in the display indicates either no tunnel endpoint
or no label distribution protocol.
To display a summary of all MPLS tunnels for the current router context:
host1:pe2#show mpls tunnels brief
name/id
vpnEgressLabel3
vpnEgressLabel4
pe2-to-pe1
Table 59 on page 362 lists the show mpls tunnels command output fields.
Meaning

Table 59: show mpls tunnels Output Fields

362
Monitoring Status and Configuration for MPLS Tunnels
tunnel not announced to any IGP
(Global) Retry forever
at (Global) interval 5 during Lsp setup if there is route
(Global) Retry forever
at (Global) interval 5 during Lsp setup if there is no route
metric is relative 0
option is currently used - path is calculated
10.10.11.5
10.10.12.3
222.9.1.3
next reoptimization in 1687 seconds
stacked labels:
222.9.1.3
State: Up
In label 20 on ATM3/0.1
0 pkts, 0 hcPkts, 0 octets
destination
0.0.0.0
0.0.0.0
1.1.1.1
2.2.2.2
Field Name Field Description
Label Label prepended to packets before being sent across tunnel
State Status of tunnel: Establishing, Traffic Engineering Negotiation, Up,
Down, Enabled with Incomplete Config, Disabled with Incomplete
Config, Disabled, or Releasing
on Location of tunnel
tunnel is announced to Protocols to which the tunnel is announced
metric Metric type, relative or absolute
phb-id PHB ID supported by this tunnel; for E-LSPs an additional exp-bits
entry is displayed after the phb-id entry
by isis
R0 Out 18 on
222.9.1.2
metric state/label/intf
R0 Incoming 1048573 on stack
R0 Incoming 1048572 on stack
R0 Outgoing 300 on atm2/0.60
R0 Incoming 3000 on atm2/0.70
tun mpls:1