Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 197

host1# show bgp ipv6 multicast
Local BGP identifier 10.13.13.13, local AS 400
4 routes (160 bytes)
4 destinations (288 bytes) of which 4 have a route
4 routes selected for route table installation
3 path attribute entries (456 bytes)
Local-RIB version 31. FIB version 31.
Status codes: > best, * invalid, s suppressed, d dampened, r rejected,
a auto-summarized
Prefix
::103.103.103.0/120
> 3ffe:0:0:1::/64
> 3ffe:0:0:3::/64
> 3ffe:0:1:1::/64
Use to display the BGP routing table.
If you specify an IP address, displays the route that best matches the specified
IP address.
Reports whether the indirect next hop of a route is unreachable; if not, displays
the IGP cost to the indirect next hop.
Field descriptions
Learned from peer Peer from which route was learned
Next hop IP address IP address of the next router that is used when a
packet is forwarded to the destination network
AS path AS path through which this route has been advertised
Aggregator AS number AS number of the AS that aggregated this route
Aggregate IP address IP address of the router that aggregated this route
Origin Origin of the route
MED Multiexit discriminator for the route
LocPrf Local preference for the route
Weight Weight of the route
Communities Community number associated with the route
Originator ID Router ID of the router in the local AS that originated the
route
Cluster ID list List of cluster IDs through which the route has been advertised
Stale Route has gone stale due to peer restart
Example 1 Displays information about routes in the IPv6 multicast address
family
Peer Next-hop
103.103.103.3 ::103.103.103.3
11.11.11.11 ::101.101.101.1
103.103.103.3 ::103.103.103.3
12.12.12.12 ::102.102.102.2
Example 2 Displays route information for prefix 10.88.88.1/32
Chapter 1: Configuring BGP Routing
MED LocPrf Weight Origin
0 0 inc.
0 100 0 inc.
0 0 inc.
0 100 0 inc.
Monitoring BGP
161