Table of Contents
Advertisement
Providing IPv6 VPN Services Across Multiple Autonomous Systems
The JUNOSe software supports inter-AS services for IPv6 VPNs in addition to IPv4
VPNs. See "Providing IPv4 VPN Services Across Multiple Autonomous Systems" on
page 391 for more information about inter-AS services and IPv4 VPNs.
The JUNOSe software currently supports only 2547bis option B for IPv6 VPNs. This
method described in RFC 4364 BGP/MPLS IP Virtual Private Networks (VPNs)
(February 2006) uses BGP to signal VPN labels between the AS boundary routers
(Figure 81 on page 399). The base MPLS tunnels are local to each AS. Stacked tunnels
run from end to end between PE routers on the different ASs. This method enhances
scalability, because only the BGP RIBs store all the inter-AS VPN routes.
Figure 81: Inter-AS IPv6 VPN Services
Use to prevent BGP from modifying the next hop sent to the BGP peer.
Outbound route maps take precedence over this command, enabling prefixes
that match the route map to be modified, regardless of this command.
Takes effect immediately.
Example
host1:vr1(config-router-af)#neighbor next-hop-unchanged 10.24.15.32
Issuing this command automatically removes the neighbor next-hop-self
configuration (enabled or disabled) on the peer or peer group. Issuing the no or
default version of this command has no effect on the neighbor next-hop-self
configuration.
Use the no version to reenable BGP to modify the next hop.
See neighbor next-hop-unchanged.
Providing IPv6 VPN Services Across Multiple Autonomous Systems
Chapter 5: Configuring BGP-MPLS Applications
399
Advertisement
Table of Contents
Troubleshooting
