Table 48: Show Mpls Interface Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

The following excerpt shows detailed RSVP-TE information for the MPLS interface:
host1:vr2#show mpls interface detail
MPLS major interface fastEthernet6/0
RSVP
Enabled with profile default
Authentication is disabled
Authentication key: <none>
Hellos are enabled
Hellos interval is 10000 milliseconds
Hellos miss limit is 4
Hello settings are not inherited
To display summary information about MPLS interfaces:
host1:pe1#show mpls interface brief
MPLS major interfaces
Admin
Interface state
--------- -------
ATM2/0.10 enabled
MPLS shim interfaces
Remote-PE
Interface LSP-name
--------- ---------
MPLS minor interfaces
Interface
----------------
pe1-to-pe2
lsp-02020202-1-4
ERX-01-0c-d7:pe1#
Table 48 on page 343 lists the show mpls interface command output fields.
Meaning

Table 48: show mpls interface Output Fields

Field Name
Interface
RSVP
LDP
IP interfaces on this MPLS
interface
Condensed location
label alloc
label learned
Oper
state
-----
up
Virtual Load
or Circuit Balancing
ID Group
------- ---------
Lower Oper
MplsMajor state Direction
--------- ----- ---------
ATM2/0.10 up transmit
ATM2/0.10 up receive
Field Description
Specifier and status of each interface
Status of RSVP, configured or not, and profile used
Status of LDP, configured or not configured, and profile used
IP address of IP interfaces and session status
Internal, platform-dependent, 32-bit representation of the interface
location, used by Juniper Networks Customer support for
troubleshooting.
Number of labels allocated and advertised to this peer
Number of labels received from this peer
Chapter 4: Monitoring MPLS
Admin Oper
state state
----- -----
Monitoring MPLS Interfaces
343