Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 400

JUNOSe 11.0.x BGP and MPLS Configuration Guide
Sending an MPLS Echo Request Packet to an IP or IPv6 Address
To send an MPLS echo request packet to the specified IP or IPv6 address:
Tracing the Path of an MPLS Echo Request Packet to an IP or IPv6 Address
To send MPLS echo request packets to discover and examine the path MPLS packets
follow to the specified IP or IPv6 address:
Sending an MPLS Echo Request Packet to a Martini Circuit
To send an MPLS echo request packet to the specified layer 2 cross-connect virtual
(Martini) circuit:
Tracing the Path of an MPLS Echo Request Packet to a Martini Circuit
To send MPLS echo request packets to discover and examine the path MPLS packets
follow to the specified layer 2 cross-connect virtual (Martini pseudowire) circuit:
Sending an MPLS Echo Request Packet to an L3VPN IP or IPv6 Prefix
To send an MPLS echo request packet to the specified L3VPN IP or IPv6 prefix:
364
Sending an MPLS Echo Request Packet to an IP or IPv6 Address
Tracing the Path of an MPLS Echo Request Packet to an RSVP-TE
Tunnel on page 365
Sending an MPLS Echo Request Packet to a VPLS Instance on page 365
Tracing the Path of an MPLS Echo Request Packet to a VPLS Instance on page 365
Issue the ping mpls command.
host1:pe1#ping mpls ip 10.2.2.2/32
Issue the trace mpls ip command.
host1:pe1#trace mpls ip 192.168.25.1/32
Issue the ping mpls l2transport command.
host1:pe1#ping mpls l2transport FastEthernet1/0.1 detail
Issue the trace mpls l2transport command.
host1:pe1#trace mpls l2transport FastEthernet1/0.1 detail
Issue the ping mpls l3vpn command.:
host1:pe1#ping mpls l3vpn vrf pe11 10.32.45.21/32