Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 225

Use to display information about BGP peer groups.
Field descriptions
BGP peer group Name of a BGP peer group
remote AS Number of the remote AS
Description Textual description of the BGP peer group
Members IP addresses of the members of the BGP peer group
Default originate Status of default origination of the BGP peer group
EBGP multi-hop Status of EBGP multihop for the peer group
IBGP single-hop Status of IBGP single hop for the peer group
BFD Status of BFD configuration for the peer group
BFD session Type and address of peer to which BFD session is established
Minimum transmit interval Desired time interval between BFD packets
transmitted to members of peer group
Minimum receive interval Desired time interval between BFD packets
received from members of peer group
Multiplier Number of BFD packets that can be missed before declaring BFD
session down
Next hop self Status of next-hop self information for the peer group
Peers are route reflector clients BGP peer group is configured as a route
reflector. This field does not appear when route reflectors are not configured.
weight Neighbor weights assigned to BGP peer groups
Incoming update distribute list Distribute lists for incoming routes, if
configured
Outgoing update distribute list Distribute list for outgoing routes, if
configured
Incoming update filter list Filter list for incoming routes, if configured
Outgoing update filter list Filter list for outgoing routes, if configured
Weight filter list Weight filter list for routes, if configured
Incoming route map Incoming route map, if configured
Outgoing route map Outgoing route map, if configured
Minimum route advertisement interval Minimum time between route
advertisements
Configured update source IP address IP address used when sending update
messages
Chapter 1: Configuring BGP Routing
189
Monitoring BGP