Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 218

JUNOSe 11.0.x BGP and MPLS Configuration Guide
show ip bgp neighbors dampened-routes
show bgp ipv6 neighbors dampened-routes
182
Monitoring BGP
Minimum transmit interval is 300 ms
Minimum receive interval is 300 ms
Multiplier is 3
Waiting for BGP to become established before initiating BFD session
Fields relevant to BFD when BFD is configured, the BGP session is established,
but the BFD protocol session is not up:
BFD is enabled:
Single-hop IPv4 BFD session to 1.2.3.4
Minimum transmit interval is 300 ms
Minimum receive interval is 300 ms
Multiplier is 3
BFD session is down
Fields relevant to BFD when BFD is configured, the BGP session is established,
and the BFD protocol session is up:
BFD is enabled:
Single-hop IPv4 BFD session to 1.2.3.4
Minimum transmit interval is 300 ms
Minimum receive interval is 300 ms
Multiplier is 3
BFD session is up for 00:00:50
Negotiated detection time is 900 ms
Fields relevant to conditional advertisement:
Advertise-map is advertisetoR1
Condition-map: trigger1
Sequence: 5
Status: Withdraw
Advertise-map is alternatetoR1
Condition-map: trigger2
Sequence: 10
Status: Advertise
See show ip bgp neighbors.
See show bgp ipv6 neighbors.
Use to display information about routes with a dampening history for the specified
BGP neighbor.
Reports whether the indirect next hop of a route is unreachable; if not, displays
the IGP cost to the indirect next hop.
If you filter the display with field options, the usual introductory information
about BGP attributes is displayed only if you issue the intro fields option. See
show ip bgp for descriptions of the fields displayed by this keyword.
Field descriptions