Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 523

Software for e series routing platforms bgp and mpls configuration guide
Table of Contents

Advertisement

Neighbor Incoming/Outgoing update prefix list Number of the prefix
list for incoming or outgoing routes
Neighbor Incoming/Outgoing update prefix tree Number of the prefix
tree for incoming or outgoing routes
Neighbor Incoming/Outgoing update filter list Number of filter list for
incoming routes
Routing for Networks The network for which BGP is currently injecting
routes
For IS-IS:
System Id 6-byte value of the router
IS-Type Routing type of the router: Level 1, Level 2
Distance Administrative distance for IS-IS learned routes
Address Summarization Aggregate addresses defined in the routing
table for multiple groups of addresses at a given level or routes learned
from other routing protocols
Routing for Networks Network for which IS-IS is currently injecting
routes
For OSPF:
Router ID OSPF process ID for the router
Distance Administrative distance for OSPF learned routes
Redistributing Protocol to which OSPF is redistributing routes
Address Summarization Aggregate addresses defined in the routing
table for multiple groups of addresses at a given level or routes learned
form other routing protocols
Routing for Networks Network for which OSPF is currently injecting
routes
For RIP:
Router Administrative State RIP protocol state. Enable means it is
allowed to send and receive updates. Disable means that it may be
configured but it is not allowed to run yet.
System Version RIP versions allowed for sending and receiving RIP
updates. The system version is currently set to RIP1, which sends RIP
version 1 but will receive version 1 or 2. If the version is set to RIP2, the
system will send and receive version 2 only. The default is configured
for RIP1.
Update interval Current setting of the update timer (in seconds)
Invalid after Current setting of the invalid timer (in seconds)
hold down time Current setting of the hold down timer (in seconds)
Chapter 5: Configuring BGP-MPLS Applications
Monitoring BGP/MPLS VPNs
487

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose

Table of Contents