Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 533

Interface Interface specifier and status; active indicates it is being used for
traffic from the core; if active is not displayed, interface is not currently being
used for traffic, but the statistics may be valid
member ports Number and type of candidate ports configured for the
group, including interface specifiers and state
member circuits Number of member circuits configured for each port and
for the group
Example 1
host1#show mpls l2transport load-balancing-group 100 member-circuits
routed to 10.9.1.3 on base LSP
load-balancing-group 100
Martini group-id 2 vc-id 200002 mtu 1500
State UP
In Label 57 on stack
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Out Label 59 on tun mpls:lsp-de090103-32-3e
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM6/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
Member Interfaces
Interface fastEthernet 2/0.2
Incoming Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Outgoing Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Interface fastEthernet 3/0.2
Incoming Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Outgoing Traffic Statistics
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
Example 2
host1#show mpls l2transport load-balancing-group member-circuits brief
4 member ports:
fastEthernet 2/0
fastEthernet 3/0
fastEthernet 4/0
fastEthernet 5/0
90 member circuits
See show mpls l2transport load-balancing-group.
Chapter 5: Configuring BGP-MPLS Applications
tun mpls:lsp-de090103-32-3e
active
down
30 member circuits
30 member circuits
30 member circuits
Monitoring BGP/MPLS VPNs
497