Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 671

Table 98: show vpls connections Output Fields (continued)
Field Name
Port Count
Interface Count
Transport Virtual Rtr
Route Distinguisher
SiteName
Transport Virtual Rtr
Multihomed priority
SiteId
SiteRange
VPLS Route Targets
Flood Next Hop
Interface
Port
Status
Connections status code
Site
State
Field Description
Number of ports currently configured for the VPLS instance,
including network interfaces and the VPLS virtual core interface
Number of network interfaces currently configured for the VPLS
instance
Name of the transport virtual router configured for the VPLS
instance
Unique route distinguisher configured for the VPLS instance
Site name configured for the VPLS instance
Identifier for the PE router that acts as the transport virtual router
for the VPLS instance
Priority of the VPLS instance to serve as the backup PE router for
the CE device in the event of a network failure in the multihomed
configuration; indicates also that the site is multihomed
Numerical site identifier configured for the VPLS instance
Maximum number of sites that can
participate in the VPLS domain associated with the VPLS instance
Extended community identifiers, also known as route targets, for
each VPLS instance configured on the router
Index number of the MPLS next hop to which the router floods
packets with unknown destination addresses. For more information
about displaying MPLS next hops and any available next-hop
statistics, see "Monitoring MPLS Next Hops" on page 347.
Type and specifier of the network interfaces and VPLS virtual core
interface associated with the VPLS instance; vpls vplsName in this
field identifies the VPLS virtual core interface
Port number of the module on which the network interface or VPLS
virtual core interface resides
Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
Possible status codes for the VPLS connection that appear in the
State field
Remote site identifier
Status of the connection with the remote VPLS instance; possible
values for this field appear in the Connections status code legend
in the command display
Monitoring VPLS-Specific Settings
Chapter 11: Monitoring VPLS
635