Configuring Ldp Graceful Restart; Figure 62: Fec Aggregation And Equal-Cost Paths - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

JUNOSe 11.0.x BGP and MPLS Configuration Guide

Figure 62: FEC Aggregation and Equal-Cost Paths

In this example, LSR 2 uses FEC aggregation, but LSR 3 does not. Consequently, LSR
2 advertises the single label e, mapped to a FEC that includes both prefixes,
10.10.22.0/24 and 10.43.12.0/24.
In contrast, LSR 3 has two FECs, one for 10.10.22.0/24 and one for 10.43.12.0/24.
A separate label is bound to each FEC. LSR 3 advertises label h for one FEC and
label w for the other FEC.
LSR 2 and LSR 3 are downstream routers for LSR 1. LSR 1 does not aggregate. Instead,
LSR 1 advertises label d for 10.10.22.0/24 and label x for 10.43.12.0/24.
To configure MPLS LDP FEC deaggregation to bind each prefix on the current virtual
router to a separate label:
Related Topics

Configuring LDP Graceful Restart

The graceful restart mechanism minimizes the negative effect on MPLS forwarding
across an LSR restart by enabling neighbors to wait for the LSR to restart and causing
the LSR itself to restart gracefully.
NOTE: Successful operation of LDP graceful restart requires that stateful SRP
switchover (high availability) be configured on the router. Although you can configure
LDP graceful restart if stateful SRP switchover is not configured on the router, the
graceful restart capability will not function.
To configure LDP graceful restart:
278
Configuring LDP Graceful Restart
Issue the mpls ldp deaggregate command:
host1(config)#mpls ldp deaggregate
Basic MPLS Configuration Tasks on page 264
Additional LDP Configuration Tasks on page 277
mpls ldp deaggregate