Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 599

Received:
0 packets
0 bytes
1 error
0 discards
Sent:
0 packets
0 bytes
0 errors
0 discards
received mtu 0
queue 0: traffic class best-effort, bound to ethernet FastEthernet2/0
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
MPLS policy input shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded:
MPLS policy output shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded:
This excerpt from the command output shows the label information displayed when
a circuit is up
host1#show mpls l2transport interface
...
Out Label 49 on
0 pkts, 0 hcPkts, 0 octets
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM1/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
...
To display summary information about MPLS shim interfaces:
host1#show mpls interface shim brief
Interface
-----------------
FastEthernet2/0.1
FastEthernet2/0.2
Table 72 on page 564 lists the show mpls interface and show mpls l2transport
Meaning
interface command output fields
Chapter 8: Monitoring Layer 2 Services over MPLS
0 packets, 0 bytes
0 packets, 0 bytes
tun mpls:lsp-de090100-24-37
Remote-PE Virtual
or Circuit
LSP-name ID
--------- -------
222.9.1.3 200001
222.9.1.3 200002
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS
Load
Balancing Admin Oper
Group state state
--------- ------- -----
- enabled up
- enabled up
563