Chapter 8 Monitoring Layer 2 Services Over Mpls - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

Chapter 8
Monitoring Layer 2 Services over MPLS
Setting Baselines for Layer 2 Services over MPLS Statistics
This chapter describes the commands you can use to monitor and troubleshoot layer
2 services over MPLS on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor and show
commands is identical to output from other E Series routers, except that the E120
and E320 router output also includes information about the adapter identifier in the
interface specifier (slot/adapter/port).
This chapter contains the following sections:
Setting Baselines for Layer 2 Services over MPLS Statistics on page 557
Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over
MPLS on page 558
Monitoring ATM Subinterfaces for Layer 2 Services over MPLS on page 558
Monitoring ATM Cross-Connects for Layer 2 Services over MPLS on page 560
Monitoring MPLS Forwarding for Layer 2 Services over MPLS on page 561
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS on page 562
You can set a baseline for the statistics for all MPLS major interface statistics on the
specified interface with the baseline mpls interface command. The router implements
the baseline by reading and storing the statistics at the time the baseline is set and
then subtracting this baseline when you retrieve baseline-relative statistics.
Use the delta keyword with the show mpls commands to display baselined statistics.
The following statistics are maintained for each MPLS shim interface:
receive packets and
octets
receive discarded packets
receive error packets
Setting Baselines for Layer 2 Services over MPLS Statistics
transmit packets and
octets
transmit discarded
packets
transmit error packets
557