Table 89: Show Bridge Port Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

JUNOSe 11.0.x BGP and MPLS Configuration Guide
host1#show bridge vplsTest port brief
------
1
2
3
Table 89 on page 622 lists the show bridge port command output fields.
Meaning

Table 89: show bridge port Output Fields

622
Monitoring Configuration, Statistics, and Status for VPLS Ports
Port Interface
-------------------------
FastEthernet1/1.1
ATM10/1.1.1
vpls vplsTest
Field Name
BridgeGroup
Port Number
Operational Status
Admin Status
Snmp Link Status Trap
Max Learn
Subscriber Policy
Statistics
In Octets
In Frames
In Discards
In Errors
Out Octets
Out Frames
Out Discards
Out Errors
Time since counters last
reset
queue
Queue length
Forwarded packets, bytes
Status
------------
Up
Up
Up
Field Description
Name of the VPLS instance to which the interface belongs
Port number on which this interface resides
Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
State of the physical interface: Up, Down
Whether SNMP link status processing is enabled or disabled for
the specified interface
Maximum number of dynamic MAC addresses that the interface
can learn
Name of the subscriber policy currently in effect for the interface
Displays statistics information for the specified port
Number of octets received on this interface
Number of frames received on this interface
Number of incoming packets discarded on this interface
Number of incoming errors received on this interface
Number of octets transmitted on this interface
Number of frames transmitted on this interface
Number of outgoing packets discarded on this interface
Number of outgoing errors on this interface
Elapsed time since statistics counters were last reset
Hardware packet queue associated with the specified traffic class
and interface
Length of the queue, in bytes
Number of packets and bytes forwarded on this queue