Table 107: Show L2Vpn Instance Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual

host1#show l2vpn instance l2vpn1 detail
L2VPN: l2vpn1
Encapsulation Type ATM AAL5 SDU VCC transport
Use of control word is preferred
Send sequence numbers
Route Distinguisher 100:11
Site Range 10
Sites:
Site Name westford Site Id 1
Multi-homed:
Site-Priority:
Route Targets:
Route Target: RT:100:2 both
Interface Local-Site-Id
---------- -------------
ATM2/0.100 1
ATM2/0.12 1
ATM1/1.1 1
Table 107 on page 677 lists the show l2vpn instance command output fields.
Meaning

Table 107: show l2vpn instance Output Fields

Field Name
L2VPN
Encapsulation Type
Use of control word
sequence numbers
Route Distinguisher
Site Range
Sites
Multi-homed
Site-Priority
Route Targets
Interface
Local-Site-Id
Remote-Site-Id
Admin state
Oper state
Yes
45
Admin
Remote-Site-Id state
-------------- -------
2 enabled
3 enabled
2 enabled
Field Description
Name of VPWS instance
Encapsulation type configured for the VPWS instance
Local preference for control word, preferred or not preferred
Local preference for sequence number, send or don't send
Route distinguisher configured for the VPWS instance
Maximum number of customer sites allowed in the L2VPN instance
Site name and site ID for each customer site in the VPWS instance
Status of the site. Yes designates a multihomed site. No designates
a site that is not multihomed.
Priority value for the VPWS instance for the multihomed site;
displayed only when the value for the Multi-homed field is Yes
Route targets configured for the VPWS instance
Layer 2 interface that is a member of the VPWS instance
Local customer site ID configured on the layer 2 interface
Remote customer site ID configured on the layer 2 interface
Administrative state of the connection, disabled or enabled
Operational state of the connection, up or down
Monitoring VPWS Instances
Chapter 14: Monitoring VPWS
Oper
state
-----
up
up
down
677