Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 624

JUNOSe 11.0.x BGP and MPLS Configuration Guide
3.
4.
5.
Related Topics
Configuring VPLS Network Interfaces
You must configure one of the following types of Ethernet or bridged Ethernet network
interfaces to transmit packets between the PE router and each CE device to which
the PE router is connected:
588
Configuring VPLS Network Interfaces
In this example, the VPLS instance forwards frames destined for the node with
MAC address 0090.1a40.4c7c out the specified Gigabit Ethernet interface
host1(config)#bridge vplsA address 0090.1a40.4c7c forward
gigabitEthernet 3/0.1
In this example, the VPLS instance drops frames sent from or destined for the
node with MAC address 1011.22b2.333c
host1(config)#bridge vplsB address 1011.22b2.333c discard
(Optional) Set the length of time that a dynamic (learned) MAC address entry
can remain in the forwarding table of the specified VPLS instance before expiring.
host1(config)#bridge vplsB aging-time 1000
(Optional) Set the maximum number of dynamic MAC address entries that the
specified VPLS instance can learn.
host1(config)#bridge vplsB learn 2500
(Optional) Enable SNMP link status processing for all network interfaces associated
with the specified VPLS instance.
host1(config)#bridge vplsB snmp-trap link-status
Configuration Tasks for VPLS with BGP Signaling on page 584
For more information about using these commands, see Configuring Optional
Bridge Group Attributes in the JUNOSe Link Layer Configuration Guide.
bridge acquire
bridge address
bridge aging-time
bridge learn
bridge snmp-trap link-status
Bridged Ethernet over ATM 1483 subinterfaces
Fast Ethernet
Gigabit Ethernet