Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 221

show ip bgp neighbors received-routes
show bgp ipv6 neighbors received-routes
show ip bgp neighbors routes
show bgp ipv6 neighbors routes
host1#show ip bgp neighbors 192.168.1.158 received prefix-filter
ip prefix-list filter 192.168.1.158 for address family ipv4:unicast
seq 5 permit 10.1.1.1/32
seq 10 permit 10.1.1.2/32
seq 15 permit 10.1.1.3/32
See show ip bgp neighbors received prefix-filter.
Use to display routes originating from the specified BGP neighbor before inbound
policy is applied.
Reports whether the indirect next hop of a route is unreachable; if not, displays
the IGP cost to the indirect next hop.
If you filter the display with field options, the usual introductory information
about BGP attributes is displayed only if you issue the intro fields option. See
show ip bgp for descriptions of the fields displayed by this keyword.
Field descriptions
Prefix Prefix for the routing table entry
Peer IP address of BGP peer
Next-hop IP address of the next hop
MED Multiexit discriminator for the route
LocPrf Local preference for the route
Weight Assigned path weight
Origin Origin of the route
Example
host1#show ip bgp neighbors 192.168.1.158 received-routes
Local BGP identifier 111.111.111.111, local AS 444
0 routes (0 bytes used), 0 distinct destinations (0 bytes used)
0 routes selected for route table installation
0 path attribute entries (0 bytes used)
Status codes: > best, * invalid, s suppressed, d dampened, r rejected
Prefix Peer
>0.0.0.0/0 192.168.1.158
>13.13.13.13/32 192.168.1.158
See show ip bgp neighbors received-routes.
See show bgp ipv6 neighbors received-routes.
Chapter 1: Configuring BGP Routing
Next-hop MED LocPrf Weight Origin
192.168.1.158
192.168.1.158 0
Monitoring BGP
0 IGP
0 IGP
185