Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 669

Multihomed priority:
Connections status code:
UP = Operational
SC = Local and Remote Site Identifier Collision
EM = Encapsulation Mismatch
OR = Out of Range
DN = VC Down because Remote PE Unreachable
LD = Local Site Down
RD = Remote Site Down
AS = Max BGP AS path length exceeded
OL = No Out Label
LN = Local Site not Designated
RN = Remote Site not Designated
Site State Remote PE
----- ----- ---------------
2 UP 3.3.3.3
3 UP 5.5.5.5
host1# show vpls connections details
BridgeGroup: vpls1(vpls)
Bridge Mode:
Aging Time:
Learning:
Max Learn:
Link Status Snmp Traps: Disabled
Subscriber Policy:
Port Count:
Interface Count:
Transport Virtual Rtr:
Route Distinguisher:
SiteName:
SiteId:
SiteRange:
VPLS Route Targets
Route Target: RT:100:1 (both)
Flood Next Hop: Index 1048577
MPLS next-hop: 20, label 46, resolved by MPLS next-hop 19
MPLS next-hop: 19, resolved by MPLS next-hop 17, peer 2.2.2.2
MPLS next-hop: 17, label 82 on ATM2/0.10, nbr 10.10.10.2
Interface
-------------------------
FastEthernet3/1
vpls vpls1
Connections status code:
UP = Operational
SC = Local and Remote Site Identifier Collision
EM = Encapsulation Mismatch
OR = Out of Range
DN = VC Down because Remote PE Unreachable
LD = Local Site Down
RD = Remote Site Down
AS = Max BGP AS path length exceeded
OL = No Out Label
Site State Remote PE
----- ----- ---------------
2 UP 2.2.2.2
BridgeGroup: vpls2(vpls)
Bridge Mode:
Aging Time:
200
In-label Out-label MPLS NH Idx
-------- --------- -----------
17 36 79
18 56 54
default
300 secs
Enabled
Unlimited
default Subscriber
2
1
pe1
1.1.1.1:10
westford
1
10
Port Status
------ ------------
1 Up
2 Up
In-label Out-label MPLS NH Idx
-------- --------- -----------
17 46 20
default
300 secs
Monitoring VPLS-Specific Settings
Chapter 11: Monitoring VPLS
Up-down Time
------------
00:04:09
00:04:09
Up-down Time
------------
00:02:56
633