Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 646

JUNOSe 11.0.x BGP and MPLS Configuration Guide
There is no no version.
Clearing All Dynamic MAC Addresses for the VPLS Virtual Core Interface Associated with
A VPLS Instance
To clear all dynamic MAC address entries for the VPLS virtual core interface associated
with a VPLS instance:
There is no no version.
Related Topics
Clearing BGP Attributes for VPLS
You can use the following clear ip bgp commands to remove specific BGP attributes
for the L2VPN address family, and in one case, for the VPLS address family associated
with a specific VPLS instance.
Clearing BGP Reachability Information for the L2VPN Address Family
To clear BGP reachability information for the L2VPN address family:
Use the soft in keywords to trigger inbound soft reconfiguration. There is no no
version.
Clearing BGP Route Flap Dampening Information for the L2VPN Address Family
To clear route flap dampening information for the L2VPN address family:
610
Clearing BGP Attributes for VPLS
host1#clear bridge interface atm 3/3.2
Issue the clear bridge interface vpls command.
host1#clear bridge interface vpls vplsA
clear bridge
clear bridge address
clear bridge interface
clear bridge interface vpls
Issue the clear ip bgp command.
host1#clear ip bgp l2vpn soft in
Issue the clear ip bgp dampening command.
host1#clear ip bgp l2vpn dampening