Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 212

JUNOSe 11.0.x BGP and MPLS Configuration Guide
show ip bgp
show bgp ipv6
176
Monitoring BGP
MED Multiexit discriminator for the route
LocPrf Local preference for the route
Weight Assigned path weight
Origin Origin of the route
AS-path AS-path through which this route bas been advertised
Example
host1#show ip bgp inconsistent-as
Local BGP identifier 192.168.1.10, local AS 123
0 routes (0 bytes used), 0 distinct destinations (0 bytes used)
0 routes selected for route table installation
0 path attribute entries (0 bytes used)
Status codes: > best, * invalid, s suppressed, d dampened, r rejected
Prefix
> 4.0.0.0/8
4.0.0.0/8
See show ip bgp inconsistent-as.
See show bgp ipv6 inconsistent-as.
Use to display all routes with a prefix that is equal to or more specific than the
specified prefix.
Reports whether the indirect next hop of a route is unreachable; if not, displays
the IGP cost to the indirect next hop.
If you filter the display with field options, the usual introductory information
about BGP attributes is displayed only if you issue the intro fields option. See
show ip bgp"show ip bgp" on page 160 for descriptions of the fields displayed by
this keyword.
Field descriptions
Local router ID BGP router ID of the local router
local AS Local autonomous system number
paths Total number of routes stored in the BGP routing table. If several
peers have advertised a route to the same prefix, all routes are included in
this count.
distinct prefixes Number of routes to unique prefixes stored in the BGP
routing table. If several peers have advertised a route to the same prefix,
only the best route is included in this count.
paths selected for route table installation Number of routes in the BGP
routing table that have been inserted into the IP routing table
Next-hop MED LocPrf Weight AS-path
0.0.0.0 1
192.168.1.1 0 11488
32768 empty
701 1