Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 520

JUNOSe 11.0.x BGP and MPLS Configuration Guide
show ip interface vrf
484
Monitoring BGP/MPLS VPNs
Reachable (metric 0)
Number of direct next-hops is 1
Direct next-hop ATM4/0.61 (10.61.61.2)
Resolution in IP tunnel-route table of VRF pe22
Not reachable
Reference count is 2
See show ip bgp next-hops.
Use to display information about the interfaces associated with the specified
VRF.
Field descriptions
interface Interface type and interface specifier
interface status Status of the interface
line protocol Status of the line protocol
Link up/down trap Status of SNMP link up/down traps on the interface
Internet address IP address of the interface
Operational MTU Actual MTU for the interface
Administrative MTU Configured MTU for the interface
Operational speed Actual speed
Administrative speed Configured speed
Discontinuity Time Value of sysUpTime the last time the integrity of the
interface statistics was compromised
Router advertisement Whether routes are advertised; enabled or disabled
Administrative debounce-time Configured debounce behavior, enabled or
disabled. If enabled, indicates time in milliseconds that the router waits
before generating an up or down event in response to a state change in the
interface. If the state changes back before the debounce timer expires, no
state change is reported.
Operational debounce-time Current debounce behavior, enabled or disabled.
If enabled, indicates time in milliseconds that the router waits before
generating an up or down event in response to a state change in the interface.
If the state changes back before the debounce timer expires, no state change
is reported.
Access routing When enabled, an access route is installed to the host on
the other end of the interface
Multipath mode Algorithm used for ECMP: hashing of destination address
and source address, or round-robin