Juniper JUNOSE SOFTWARE FOR E SERIES 11.0.X - BGP AND MPLS CONFIGURATION GUIDE 2009-12-30 Configuration Manual page 522

JUNOSe 11.0.x BGP and MPLS Configuration Guide
show ip protocols
486
Monitoring BGP/MPLS VPNs
Operational MTU = 9180
Operational speed = 155520000
Discontinuity Time = 0
Router advertisement = disabled
Administrative debounce-time = disabled
Operational debounce-time
Access routing = disabled
Multipath mode = hashed
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
Out Forwarded Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
Out Scheduler Drops Committed Packets 0, Bytes 0
Out Scheduler Drops Conformed Packets 0, Bytes 0
Out Scheduler Drops Exceeded
Out Policed Packets 0, Bytes 0
host1#show ip interface vrf vpn1 brief
Interface
null0
atm4/0.77
See show ip interface vrf.
Use to display information about the routing protocols associated with the VRF.
You must specify the name of the VRF for which the protocols are displayed;
otherwise, the command displays all protocols configured on the router
Field descriptions
For BGP:
Redistributing Protocol to which BGP is redistributing routes
Default local preference Local preference value
IGP synchronization Status of IGP synchronization: enabled, disabled
Always compare MED Status of multiexit discrimination: enabled,
disabled
Router flap damping Status of route dampening: enabled, disabled
Administrative Distance External, internal, and local administrative
distances
Neighbor Address IP address of the BGP neighbor
Neighbor Incoming/Outgoing update distribute list Number of the
access list for outgoing routes
Administrative MTU = 0
Administrative speed = 0
= disabled
Packets 0, Bytes 0
IP-Address Status Protocol Description
255.255.255.255 up
7.8.7.7 up
up
up